How to remove the noise of Zoom G1xOn

I've had several questions on my channel on how to remove the noise or hum of Zoom G1xOn and my answer to them normally are: Check if it's the power adapter causing it, if it's the guitar lead, if it's the amp, or try the battery option. But, I've really never considered to check the pedal itself. Because Im quite happy with my Zoom G1xOn and have used it during gigs, rehearsals and even recordings. And, Im happy with it, my bandmates are happy and even the sound engineers are happy with my pedal.

However, recently, I made a video as an experiment or comparison for my Zoom G1xOn by using two different guitars and used different leads plus trying out plugging the Zoom G1xOn directly to an audio interface versus guitar amp. I was surprised that it was not the guitar or pickups or amps or leads that's causing the noise, it's really the pedal.

Here's the video that I did:

So, after I watched this video, it made me think that there should be a solution somewhere. And so, by pure luck, YouTube recommended a video for me from AshBass5 about noise reduction for Zoom G3, G3X, G5 and I've watched the video and learned from something from him. I thought, aha, I can use this for Zoom G1xOn.

So here it is. This is how to remove or minimize the noise of your Zoom G1xOn. Just go to EDIT and add effects, scroll and look for ZNR, then either turn the DETCT to Gtr-In and turn the THRSH up to 17 or 18. Or, you can leave the DETCT as Efx-In but put the effects first on the chain before the amp.

Hope you learned something useful here and please don't forget to subscribe on my blog as well as on my YouTube channel. All the very best to you guys. See you later!

Mosky 4-in-1 DTC delay converted to spring reverb

Here's how I converted the delay pedal into a spring reverb. It is very useful if your amp doesnt have reverb or you dont have a reverb pedal. Also reverb effects pedal is more expensive than delay pedal.

I put the level to 1 o'clock, delay at 9 o'clock, and repeat at 9 o'clock. It might vary, depending on what delay effects pedal you've got. But, for this Mosky 4-in-1 DTC, this settings works. Also if you don't have acoustic simulation effects pedal, this could be the solution.

Then I setup my overdrive for boost during lead or as a rhythm crunch. Level at 1 o'clock, drive 8 o'clock, and tone at 10 o'clock.

Distortion setup volume 1 o'clock, presence 1 o'clock, tone 10 o'clock and gain at 2 o'clock. I use this during lead or heavy distorted rhythm

Gear used:

Lyon by Washburn electric guitar, neck pickup.
Plug to Mosky DTC 4-in-1
Then out and into my Behringer GDI21
(It's like a DI box/amp simulator. I used the clean fender-ish option.)
Then out and plugged to Focusrite iTrack pocket
To to my iPhone 7 using Impact app that comes with the Focusrite iTrack Pocket.

Mosky 4-in-1 DTC overdrive as boost

How to setup your Mosky DTC 4-in-1 overdrive as booster pedal for your distortion.

1. Overdrive volume/level should be all the way up. Then gain/drive around 3 o'clock. Tone 9 o'clock.

2. Distortion volume/level 12 o'clock, Tone 11 o'clock, Presence 1 o'clock, Gain 8 o'clock, Voice/mode on high.

3. Delay is optional but here's my setup Level 11o'clock, Delay 8 o'clock, Repeat 9 o'clock.